A Flash Developer Resource Site

Results 1 to 3 of 3

Thread: Load/Unload movie problem

  1. #1
    Junior Member
    Join Date
    Mar 2001
    Posts
    20
    hello, this is my problem:

    i have a main movie with a border and a bakground.there's a button that should load a second section into the movie. but how do i make is so that it wont go over all my layers on the first movie?cause i want it to just go over the background and not the rest of the stuff.can you help plz?
    thx

  2. #2
    Member
    Join Date
    Mar 2001
    Location
    Venice, CA
    Posts
    88
    I'm not sure I fully understand the question, but if you're looking to swap backgrounds you could add another level:

    level0 : no artwork, blank movie that really just acts as an "anchor" (maybe it stores your variables too)
    level1 : your backgrounds swap in and out here
    level2 : the rest of your movie's content (will always display on top, unless you use other levels).

    An alternative is to create a one-level movie (level0) where the bottom layer is a MC with a keyframe for each background, and then you could use tell target to go to a particular background depending on what you needed.

  3. #3
    Junior Member
    Join Date
    Mar 2001
    Posts
    20
    thx!i think i'll do it the second method you mentioned

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  




Click Here to Expand Forum to Full Width

HTML5 Development Center