I am using a Roll in Swiss Roll and am trying to figure out, is it possible to make the path have more nodes. Do I have to tie multiple roll effects end to end or is there a way to modify the path?
I'm not familar with it
can you provide the .sfx or an swi demonstrating it?
I don't think you'll be able to adjust the path points
Only start and middle (it really depends on the sfx)
(I'd need to see the sfx)
However you may be able to place the object in a sprite
and apply a separate effect to the sprite itself.
Usually you can control the span area thru placing it in
a sprite.
Actually it looks as if this one is not really very customizable - no start, middle, end controls (it is under Appear Into Position in the Effects listing). You could move it while the effect is on (under the motion tab) but not along a path without multiple effects.
Thanks for the replies. What you posted seems quite a bit different than what I am trying to do.
The attached file is similar to a bigger one that I am working on. What I would like is for the button to make a couple of jogs in its path on the way in.